|
Northeast ND | Have a 2600 display in a red tractor running a 1890/1910 air drill. Been running this setup for 10+ years, and had a brand new problem today. Was seeding and it stopped tallying acres. Noticed fan speed wasn't fluctuating like it usually does either. Then clutch failed to disengage. Looked at Configuration page to see if I needed to redo the lift switch configuration, and all the cart configuration numbers were wrong. Sprocket tooth counts, drill width, etc.
Powered down and restarted. Configuration was back to what it was supposed to be. Acres showed up. Worked normally.
A few hours later, noticed it stopped tallying acres again. Configuration was wrong again too. Restarted, worked normally.
Any ideas? This is a brand new problem! Thanks
(20230519_210740 (full).jpg)
(20230519_211138 (full).jpg)
(20230519_211235 (full).jpg)
Attachments ---------------- 20230519_210740 (full).jpg (92KB - 85 downloads) 20230519_211138 (full).jpg (93KB - 79 downloads) 20230519_211235 (full).jpg (94KB - 83 downloads)
| |
|