|
IA | Have a jd 8200 with small hyd pump. Running an incommand 1200 for steering and planter monitor, 7500 receiver on terra star c, z2 steer command and AL hydraulic steering control. I cannot get the steering to engage until im a 3rd of the way through the pass. It will say it's engaged the icon on the screen is lit up green but it is not physically steering the tractor. The correction measurements at the top of the screen also show accurately how far off it is and the monitor knows it's off. I have not tried a wheel angle sensor cal yet because I'll have to unhook the planter to do it. The steering valve block had a leaking plug fitting with a bad oring that we thought might be the issue but that has been addressed, and it's still not steering correctly. When it finally does start to steer it works good. System was all installed 3 weeks ago but a reputable dealer. Any ideas on what I have going on?
(IMG_20230428_160422829_HDR (full).jpg)
Attachments ---------------- IMG_20230428_160422829_HDR (full).jpg (166KB - 83 downloads)
| |
|