|
West Central IA | https://www.youtube.com/watch?v=1uY4SV5VbVU
https://www.youtube.com/playlist?list=PLXi34S0BOg45FpYCwR-Vu3rmc4rp-...
The first is the table build that I used. The second is a guy who built the same, but had less skill and didn't do everything right so his was a short lived machine. I think he got a couple of years out of it, but had lots of trouble. If a guys skills are some where in between these 2 it is easy except for learning the programs and troubleshooting. I added a camera and scanning program to mine so I can duplicate a part from a new part. Example, I traced the repair side sheets for a big round baler so I could cut replacements out of ar plate so they will last the rest of the life of the baler. Need something like this as there are holes that need to be indexed in the repair sheet so they are a bolt on weld in place set up. | |
|
Shout out to YouTube
