|
northeastern Ohio | I have a 1" hydraulic hose with a leak where it makes a sharp bend. It is a low pressure return line. It is over 20 feet long and snakes through the machine which makes it hard to remove.
I would like to cut out the bad spot and put in a 90 degree fitting with barbs on both ends. I googled but can't find what I am looking for. I can find them for water lines, but they seem to be too big to fit into the very inflexible hydraulic hose. I tried the one pictured below, but it won't fit.
Can someone point me in the right direction?
(31vmZHHIUoL._AC_ (full).jpg)
Attachments ---------------- 31vmZHHIUoL._AC_ (full).jpg (18KB - 166 downloads)
| |
|