|
Ethridge, TN | Where "exactly" are you loosing the oil? If it's out of one of the hose coupler, it doesn't take very long to put in a new set of o-rings.
Parts needed per SCV.
2 - RE186599 Kit
1 - RE186600 Kit
2 - R222761 O-Ring
It's fairly straight forward to change it out. Take out the 3 star headed screws that hold the dust cover. Remove the snap ring that holds the coupler in the housing. Push/pull the disconnect lever to un-seat the coupler. There is another small snap ring that will allow the sleeve to be removed, careful that you don't loose any of the small steel balls. Replace the o-ring and back-up ring, and the o-ring and back-up ring on the internal part of the coupler and put the sleeve back on, and the new snap ring. Inside the housing, is a second o-ring/back-up ring combo. Replace the white o-ring on the outer part of the coupler and snap the unit back into the housing, and replace the previously removed snap ring. a break-down sheet of the components is in the kit packages. | |
|
8120 valvestack leak
