|
nc ks | no, it is actually a hole that the bushing slides in to and is a little deeper than half the bushing depth. Do you think bearing mount would adhere to the plastic or would that be a waste of time? I also think that if I tighten the 3 center bolts a little tighter that it will snug things up some. Tried it before I took some of the wheels apart hoping to delay any fixing until the bearings actually went out, but the bushing is just worn too much to tighten up. It suprizes me that it wore the steel bushing that much and didn't totally destroy the plastic piece. | |
|
guage wheels on JD 1770NT with ME plus units bearing loose in plastic outer wheel
