|
Lee Co | I am running the rotor at slowest possible 250 rpm no load, cylinder at 1 fan at 1300 speed 4-5 mph corn 14% yield monitor at 200-210 grain loss at almost o have to watch screen to see a light com on (2166 w/ 6 rowx30) if I remember, vanes ar set to mid allo exept last 2 they're at fast. I have a may-wsclean grain chain in it otherwise I don't think you could get the corn away from the auger bed fast enough. it doesn't cascade as bad as the factory rubber flights and is more efficient at carrying corn up. only trouble is we wore out the outside plate on the lower boot this fall with all the dry corn. the dry corn is much more abrasive then higher moisture corn and wares everything faster.
| |
|
1660 rotor speed in corn?
