|
| Thanks Ted, I think I ave it all straightened out. I made a dummy weatherpak and connected jumper pack direct to motor and it ran full speed ahead. Then I made a couple dummy wires and hooked jumper pack to power strip outlet that I had on the end and the motor just sounded terrible and would barely turn over. Instead of going to power strip in the cab I went straight to battery. Seems to operate fine, BUT there is a miss in the light every once in a while, and the lower volume I get the worse it gets. I played with the flow sensor jam nut a little and got it as good as I can but at 22 oz. it wants to skip a beat every once in a while, but the motor and output of the line doesn't seem to vary. Maybe that is normal, don't remember from the past years. Thanks again.
| |
|
Raven Sidekick problem
