|
| Hi everyone. I recently purchaced a EZ-Boom 2010 Switch box to connect to my EZ-Guide 500 to control my Trucount air clutches on my planter. I am not sure how to set the 500 up to run my clutches. I believe i have all the right cabling, 61437 and terminator 59783 between the 500 and switch box. And 75638 from switch box out to clutches. I don't have any power going out to the clutches no matter how I flip the switches. I am not sure if I have the 500 set up right. I don't have a user guide or quick start card. The LED on the switch box comes on and the section icons on the display change state when I flip switches. I looked on Trimbles website for a user guide but I didn't see anything that explains how to correctly set up the display for clutch control. How do I set up the display? | |
|
EZ-Boom Tru Count set up
