AgTalk Home
AgTalk Home
Search Forums | Classifieds (7) | Skins | Language
You are logged in as a guest. ( logon | register )

1480 rub bars
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
Old Pokey
Posted 8/6/2006 11:51 (#33184 - in reply to #33176)
Subject: RE: 1480 rub bars


IMO, you likely dont need to shim them then. I run some red clover and occaionally some crimson clover. I run a seed plate that has a series of rubber bars across it to better retard the material and make it easier on the seed. For this, it is a good idea to shim the bars, as if you dont, a high bar will wear a groove in the seed plate, reducing its effectiveness. Much the same as if you run the metal concave up tight against the rotor, you'll have only the high bar set to thresh properly. But, that is just my opinion, so dont take it as fact.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)