AgTalk Home
AgTalk Home
Search Forums | Classifieds (72) | Skins | Language
You are logged in as a guest. ( logon | register )

Trimble Field-iq and Muller presure sensor 30303591
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
Posted 11/16/2023 12:56 (#10484420 - in reply to #10483115)
Subject: RE: Trimble Field-iq and Muller presure sensor 30303591 in Lodz, Poland has a good selection of WIKA and other quality pressure transducers.
Most of them are industry standard 8 - 30V input and 4-20mA output. Lots of WIKA sensort around 100 €/$.
I ususally get all the connectors etc from there.

Low cost chinese can be found from ebay and Aliexpress.

To get 1-5V from 4-20mA pressure signal You just simply use a 250 ohm resistor between signal and signal ground connectyors of your Field-IQ.

I would imagine that your Arrag sensor 4-20 mA 20 bar should be just fine.

I will enclose a simple scheme how to wire the sensor and the resistor and also a Field-IQ paper with usefull information of pinouts etc.

Good luck!

Edited by Artic 11/16/2023 14:02

(IMG_20231116_194031 (full).jpg)

Attachments IMG_20231116_194031 (full).jpg (46KB - 6 downloads)
Attachments Field-IQ_Install_99104-05-ENG_Generic_AW.pdf (1423KB - 8 downloads)
Top of the page Bottom of the page

Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)