|
| Have a new to me lexion combine. Previous owner said yield monitor didn't work, but I decided to try it.
I got the gps and edge display working. I am getting yield data but no moisture.
I took auger apart and cleaned it all up. I found the motor for the auger locked up. I have replaced that and it's running. At first it was running all of the time, so I adjusted the proximity switch and it kicks in and out.
It still reads 0 all of the time for moisture. When I go to the edge calibration screen, it says it has a -28 offset on the moisture. However it will not let me change it. I can put it in manual and adjust, but in auto it will not allow me to change the moisture offset.
It is changing on the raw data in the field. I have attached a photo of the raw data. Any ideas on what to try next?
 (20230913_201628 (full).jpg)
Attachments
----------------
 20230913_201628 (full).jpg (78KB - 16 downloads)
| |
|
Agleader edge and moisture se sor
