|
| Running a Kinze ASD planter and using an AgLeader InCommand 1200 for population monitoring. All of the sensors load fine into the InCommand, including all the rows, the shaft speed sensors, and the bulkfill pressure sensor. However, when I go to calibrate the pressure sensor, it has this "Offset" value on the screen as seen below. No matter what pressure reading I try and put in the gray box, say if the analog meter says 20 and I try to enter 20 into the reading, all it does is go back to five. Then that is all the pressure shows when planting even if it is much higher than five (and it shows five as a pressure reading even when there is no pressure being applied). How can I change that and get this to work?
Edited by Aslongasitruns77 5/25/2023 06:10
 (0523231842a (full).jpg)
Attachments
----------------
 0523231842a (full).jpg (64KB - 140 downloads)
| |
|
Kinze ASD pressure reading on AgLeader InCommand help
