|
Alabama | I'm trying to replace a Raven 440 and have my GFX 750 perform rate and section control. I believe I have all the hardware wired correctly - Rate and Section Control Module 75774-01, Raven replacement cable 88644 and a Field IQ to GFX Display cable 111083.
I need some help setting up the software side now. These are settings screens I've inputted so far but I don't know if they are correct. I don't know the pin locations on the Raven cable and how to input those settings. Any help is greatly appreciated.
Edited by JDW2 5/24/2023 00:31
(IMG_1724 (full).jpg)
(IMG_1725 (full).jpg)
(IMG_1726 (full).jpg)
(IMG_1727 (full).jpg)
(IMG_1728 (full).jpg)
(IMG_1729 (full).jpg)
(IMG_1730 (full).jpg)
(IMG_1717 (full).jpg)
(IMG_1718 (full).jpg)
(IMG_1719 (full).jpg)
(IMG_1720 (full).jpg)
(IMG_1721 (full).jpg)
(IMG_1722 (full).jpg)
(IMG_1723 (full).jpg)
Attachments ----------------
IMG_1724 (full).jpg (61KB - 52 downloads)
IMG_1725 (full).jpg (62KB - 51 downloads)
IMG_1726 (full).jpg (74KB - 56 downloads)
IMG_1727 (full).jpg (69KB - 52 downloads)
IMG_1728 (full).jpg (63KB - 50 downloads)
IMG_1729 (full).jpg (62KB - 59 downloads)
IMG_1730 (full).jpg (80KB - 52 downloads)
IMG_1717 (full).jpg (68KB - 55 downloads)
IMG_1718 (full).jpg (92KB - 50 downloads)
IMG_1719 (full).jpg (66KB - 61 downloads)
IMG_1720 (full).jpg (82KB - 56 downloads)
IMG_1721 (full).jpg (68KB - 53 downloads)
IMG_1722 (full).jpg (68KB - 50 downloads)
IMG_1723 (full).jpg (63KB - 49 downloads)
| |
|