|
| Yes there are. See page 23 on this document: https://www.newhollandplm.com/upload/6f706cea-2732-45ae-ab8d-2239101...
You need to use the TX and RX wires for port 3. Confusingly enough I believe in the RDI/AGRemote setup, it might refer to this as Port C. Serial Port 2 (or Port B) always defaults to TSIP when the receiver is reboot, if I'm not mistaken. But if you set Port 3(C) to OUTPUT NMEA and INPUT RTCM, that should work with CORS. If CORS requires NMEA for resolving the nearest VRS, then make it GGA only, and does not need to be more than 1 hz.
Edited by torriem 1/24/2023 21:40
| |
|
Cnh 372
