Posted 6/26/2022 20:41 (#9722709 - in reply to #9721563) Subject: RE: How does a STS combine "identify" the connected header?
NW MN
On one of heads we need to unplug the 3 flex mode sensors. They are on the back side of the head, under the top bar. One on the left and two on the right.
The combine will then “see” the rigid sensors rather then the flex sensors. Need to remember to plug back in flex sensors when calibrating for flex mode.
This is after unpinning the rigid mode sensors under the head
How does a STS combine "identify" the connected header?
