|
| Well, I think my problem is with the firmware on the ez-pilot system. I go to upgrade modules and it shows the IMD_600 and the SAM-200. I can update the IMD 600 but when I go to update the SAM-200 it says to connect it to port A of the TM-200. Cabling guide says to plug it into the R4 can port but I still have the cable from my FMX that will plug into port A. I tried that and it would still update the IMD 600 but it it still gave me the same “plug into port A” error when I try to update the SAM-200. Any suggestions? | |
|