AgTalk Home
AgTalk Home
Search Forums | Classifieds (64) | Skins | Language
You are logged in as a guest. ( logon | register )

Outback S2 correction
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
Posted 6/16/2022 07:54 (#9707890 - in reply to #9706271)
Subject: RE: Outback S2 correction

Hiawatha, KS
To reset the SBAS Satellite on an S2, follow these steps: Menu>Scroll down to Service, hit Enter>Scroll down to SBAS Satellite, hit Enter>use your arrow keys to change it to 131, 133, or 135. If it takes a long time to get signal after that you may need to do an Erase Flash Procedure, follow these steps: 1. Disconnect the antenna cable from the S2 while powered on. 2. Push Stop Guidance then Enter, you are looking for BD Menu-Keyboard Test to show on the screen. It may take a few tries. If after 5 attempts it does not show, turn off the S2 and then power it on again. Once the LED lights are done cycling, you can try Stop Guidance then Enter again. 3. Once the BD Menu-Keyboard Test is on the screen, use your down arrow until the cursor points to Erase Flash, hit Enter. It will say Erasing Flash and have a countdown. The LED lights will cycle when completed. Once the LED lights have cycled, turn off the S2 and reattach the antenna cable then turn it back on. Give it a little while to start tracking satellites again.

If you wish you can contact Outback Guidance Customer Service/Tech Support at 1-800-247-3808 8am-5pm CDT Mon-Fri (Excluding holidays). One of our support specialists will be happy to assist you.
Top of the page Bottom of the page

Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)