|
| Lefebure Windows NTRIP Client will start getting the stream from caster also without a receiver serial connection.
For streams that need location just choose "Use manual location".
This is an easy way to find out that the NTRIP settings are ok.
To get the CRM+ stream to the 252 receiver I used pins
on Port B (the right hand side):
5 = signal ground
6 = port 3 RS232 Tx OUT
8 = Port 3 RS 232 RX in
pin 10 V+IN/OUT was used to to get the 12V to the BT-Serial adapter.
So you have to set up the ports right first.
Sometimes it helps to swap TX & RX!
The left connector (Port A) was used to connect the receiver to an EZ-Guide 500 receiver.
I will enclose the user guide for AG252.
Pinouts are on pp 24-26.
They should be the same on ag-262. I could not find a 262 guide, but found a AG-372 guide from internet and it has the same pinouts.
To get EGNOS working make sure you have selected the right satellite number. 123 and 136 should be operational right now
https://egnos-user-support.essp-sas.eu/new_egnos_ops/egnos_system_re...
Edited by Artic 5/31/2022 12:59
(IMG_20151010_151135 (full).jpg)
Attachments ---------------- IMG_20151010_151135 (full).jpg (70KB - 167 downloads) AgGPS252_100A_UserGuide_55510-00-ENG.pdf (2113KB - 167 downloads)
| |
|