|
| To my understanding You can not configure a Teltonika router NTRIP client with a Trimble receiver or display.
So the teltonika devivce has to start up getting the CMR stream from the caster and pushing it to 262 by itself just like the Android NTRIP client does.
If client position is needed for that: use teltonika position if awailable or receiver position (set it to the port used by AgRemote).
A RTK unlocled 262 should get RTK FIX when it receveves a valid CMR /CMR+ correction stream to port 3 (the second serial port on blug B, the right hand side) if it is configured the to take them in. I really do not remember if the input should be named CMR, RTKLINK or what ewer but it sure is doable.
To my knowledge for CMR RTK there is also a max distance of 300 km to RTK work. It might be possible that the caster starts streaming the "default position" if it does not get your "about" position and you are too far from it...
| |
|
rtk
