|
| So the deere tech was out this morning. Hooked up his computer, There was nothing on the hardware or sensor related that would cause the issue. But he did do a calibration where we drove straight (down the road) at 16 mph for 60 seconds and that was to calibrate the wheel sensor to zero if I understood correctly. Once we did this and went back to the field and tried it, it felt like we inproved a lot like sub 2inch hunting back and forth. We then adjusted a couple sensitivity’s up from 100 to 125 and it improved some more. I did notice the small rod that connects to the arm where the wheel angle sensor is located had some play in it so I might replace that and see if that helps some more. Pretty disappointing to pay for Sub 1inch accuracy and settle for 6-8inch. | |
|