|
Central MI | Seeding with a jd 1990 drill. Under the blockage monitor in the population tab you have the option to use GPS as your speed source. When I set it to GPS I get no ground speed detected. I am running all this through a 2600 monitor that is set up as a standalone system for population monitoring and mapping only. Auto steer is independent and not tied into the 2600. I have an ITC globe for speed and position and was told that would feed the population monitor my speed but evidently that is not the case. Speed and position is displayed and accurate on the performance monitor/mapping side. I do not have a radar tied into the system, the ITC is plugged into my ISO harness via an ag express expansion harness and the 4-pin radar connection. Is there a way to get the ITC to input speed into the population monitor?
Edit: Under the diagnostics tab of the blockage monitor the ground speed is displayed from the ITC. Wheel and gps speed remain at zero.
Edited by DumbOleFarmer 5/22/2022 13:58
| |
|