|
Sunnyvale, CA | a possible source of confusion is the EZ-Guide plus has an older version of code 3.01 while the correct and latest is 3.10 and the EZ-Steer controller firmware is 3.01
It is also important to calibrate T2 to take out the roll offset. If your EZ-Steer diagnostic screen has a roll offset of 0.0 degrees, it most likely means that you have not run the calibration. the number should be small (like 1.3 or 2.4 degrees and NOT 0.0 unless you were unusually luck to mount the EZ-Steer controller on a perfect surface parallel to the ground with perfectly even roll balance in the tractor) | |
|
ez steer
