| scottinswil1 - 7/28/2022 16:52
This is on a 3500 series planter. I cannot get this monitor to read population or acres correctly. The acre counter adds up extremely fast. We bought this thing used from a jockey that advertised it with only 2500 acres. It is a 2001 or model in decent shape, but I highly doubt the monitor showed the right acres. I had it sent to Ag Express this winter and they said everything was fine. Here are a couple of pictures of what it reads while planting. Either I have a wiring issue on the planter or I am stuck in some part of the set up mode on the monitor itself.
Top pic is the population and #2 is what it shows for spacing while planting
Did you read the manual, drive the correct distance, and enter the correct calibration number?
Did you confirm the number of rows and row spacing is entered correctly?
Does the speed on the kpm match gps speed?
Can you confirm that the correct seed sensors are on the planter? I believe there were two different types of those kinze sensors, i cant recall for sure, but some had blue connectors and some black, but they don’t interchange one way or the other.
If all else fails, I would start from step one in the manual and start over completely. All the sensors will need to be unplugged and plugged back in order etc. it sounds complicated, but its really not if you follow the manual exactly step by step.
Edited by sparrell 7/28/2022 18:28
|
Kinze KPM II problem?
