|
North east Illinois | If any of you guys figure it out I'd like to know. Our '90 7130 has 3 pt. problems too, has a code "S" that means load sensing pin, mech said to unhook wires to the pins and 3 pt. should raise and lower like normal, in position control mode. We are drilling beans w/ 3pt. drill and sometimes it will lower just fine and half the time it will act up and take maybe 15-20 seconds to lower no matter where the lower speed knob is set . We're almost done now, so just living with it, but mech at dealer is "looking in to it" . | |
|
Magnum guys....asap.....Neighbor could use some help!!
