|
MN | You can sometimes get them cleaned out by taking each and every nozzle plug and nozzle out starting where the pivot is plugged. I usually take the first plug out, let the water run a while until it starts dribbling through the hole. When the water starts going you'll get a lot of sand out, wait till the water clears. Then take the plug out of the next one, do the same thing over and over again. Takes forever. Sometimes tapping on the pipe helps get it moving. We don't have any T&L's, but I don't think they're much different
This has worked for me in the past. Good luck.
Be careful, I've heard of pivots going down when they get plugged with sand like that.
| |
|
Help Pivot problem!!
