|
West Central Iowa | There are two common sizes of o-ring thread hyd couplers. #8 which is 3/4-16 thread and #10 which is 7/8-14 thread. While these are standard hydraulic end sizes the #8 was used a lot by JD and the #10 was used by IH years ago. The o-ring for the #8 end should be very available at any JD dealer as part number R26375 and current list is $1.88. The JD number for the #10 o-ring is R26906 and current JD list is $2.22. If you need a lot of them you may want to check with a hydraulic supply house as I am sure you could find them a lot cheaper then from JD. A&I shows them for a little less then JD and I am sure Case-IH would have them too, but I am not sure of the part numbers. | |
|