|
| I recently purchased a 2000 Sterling AT9500 with a N14-370E. The charged air cooler was bad in the process of changing it I noticed the hot side pipe had pinholes rusted through on the bottom side. They are NLA from Freightliner. I have called all the local yards and a few of the big ones with no luck. I think I can make one if I order a chunk of pipe and some high temp 30 degree boots. But figured I would check here to see if anyone knows where to get one custom made or if I should try to buy some fittings and weld my own (have a MIG and TIG I could use).
It's 4.5" OD pipe. 16" long. 4.25" offset.
Any ideas?
(IMG_6575.JPG)
(IMG_6467.JPG)
Attachments ---------------- IMG_6575.JPG (106KB - 226 downloads) IMG_6467.JPG (148KB - 264 downloads)
| |
|
|