|
NE Ohio | Thanks everyone for the comments.
It is a new fence installation. It sounds like there is no "universal" best method. Perhaps the "reel-tite" tensioners suggested by Guypatrick are the key for tightening up any sag later. However, for initial installation it sounds like the method is to install the wire end to end (wrap at the end braces) and hand tighten as much as possible. It sounds like the only way to get tighter than this is to cut the wire and pull both ends with a fence repair tool. Is this correct?
Thanks again,
-Nick | |
|
How to tighten barb wire fence?
