Near Intersection of I-35 & I-90 Southern Mn. | Just read Ag Leader's TSB-003004 which addresses this issue.
Apparently it has been observed by others and the problem seems to come about when the vehicle "backs up" such as I did.
This can cause probems with Autoswath as would be used with Seed Command or other applications. For me there was no problem with the planting but just the map.
The solution that is suggested is to go the Setup Screen, Console and then the Advanced Parameter button.
Scroll down to select parameter number 54. Press EDIT and use the number pad to change the value from 804 to 1. After exiting the setup screens this change will take place.
I have not done this yet but hopefully this will take care of the problem.
If you have questions concerning this situation I suggest you check with Ag Leader Tech Support.
Edited by tedbear 5/7/2008 09:38
|
Insight- Coverage Map Confusion
