AgTalk Home
AgTalk Home
Search Forums | Classifieds (19) | Skins | Language
You are logged in as a guest. ( logon | register )

Putting in fence, how to keep it straight?
View previous thread :: View next thread
   Forums List -> Stock TalkMessage format
 
Galaxie64
Posted 11/17/2011 19:33 (#2054820 - in reply to #2054663)
Subject: Re: Putting in fence, how to keep it straight?


WY, OK

feelnrite - 11/17/2011 15:56 Set the post on each end first and run your bottom wire or a barb if you are putting in woven wire. Then build your braces and if you build braces before you run your wire they will be off. You use your wire to go by then.

 

That is the only way to do it and be straight with the ends.  Never once have I built a full brace without lining the end posts first and had it perfectly straight.  If you are going over a hill or a dip you should have a brace there anyway so stretching the wire with this method and dropping it in the middle works just fine.

Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)