|
Earth | The other thing you can try is go into the overlap option, change the value then change it back & then press OK. If that doesn't work, try holding down the F1 + F2 buttons when you power the unit up. This will change all your settings back to the defaults, so you might want to save your configuration first. You might find that if you reload your saved config, you end up with the issue again, so you might end up having to enter your settings manually... This issue should be resolved in the next EZ-Guide 500 firmware release due out in the next 3 to 4 weeks. | |
|
EZ 500 and implement (width) changes
