Viewing a thread - Cutting out welds- flush

Forums | Classifieds (92) | Skins | Language

You are logged in as a guest. ( logon | register )

Cutting out welds- flush	View previous thread :: View next thread
Forums List -> AgTalk Cafe	Message format

MarlandS

Posted 10/7/2010 20:41 (#1387351 - in reply to #1387338)
Subject: Re: Cutting out welds- flush

Ellsworth IL

I dunno , I've cut a few short thin welds with a sawz-all , wouldn't try a 3 ft 100% weled run but a 6 inch single bead is definately doable , if you can hold the saw steady .

Cutting out welds- flush - guessrow : 10/7/2010 18:17
- Re: Cutting out welds- flush - plowboy : 10/7/2010 18:57
  - Re: Cutting out welds- flush - Dave Cen.Ia : 10/7/2010 23:44
- RE: Cutting out welds- flush - ry0972 : 10/7/2010 20:19
- RE: Cutting out welds- flush - JoshuaGA : 10/7/2010 20:26
  - RE: Cutting out welds- flush - Angus in ncmo : 10/7/2010 21:38
- Re: Cutting out welds- flush - MarlandS : 10/7/2010 20:28
  - Re: Cutting out welds- flush - JoshuaGA : 10/7/2010 20:33
    - Re: Cutting out welds- flush - MarlandS : 10/7/2010 20:41
- Re: Cutting out welds- flush - Thud : 10/7/2010 20:50
  - Re: Cutting out welds- flush - headerpuncher : 10/7/2010 21:43
  - Re: Cutting out welds- flush - G. DAY : 10/8/2010 00:23
    - Re: Cutting out welds- flush - G. DAY : 10/8/2010 00:37
- Re: Cutting out welds- flush - Pofarmer : 10/7/2010 22:02
- RE: Cutting out welds- flush - msb : 10/7/2010 22:05
- Thanks all.... - guessrow : 10/7/2010 22:58
  - RE: Thanks all.... - Angus in ncmo : 10/7/2010 23:16
  - RE: Turn the angle on the cutting torch, - 95h : 10/7/2010 23:36
- Plasma Torch - Matt NCOK : 10/8/2010 00:12
- Use a scarfing tip.... - MDARE : 10/8/2010 12:18
  - Re: Cutting out welds- flush - scottnelsen : 10/8/2010 14:46
- Re: Cutting out welds- flush - wheat fallow : 10/8/2010 14:37

Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)