|
Holland, Indiana (SW IN) | Just a thought I've made 3 out of same pipe used for augers or grain leg down spout in your case you need 12" easy to find 8 gauge
if you were closer I have some below the hill "I keep everything"
One on a Case excavator (Case wanted $3000) and a couple others
Weld in some baffles out of 1/4" flat steel be creative but don't block too much air flow-- tear apart and copy your old muffler
I used 1/4" flat for the ends and bought exhaust pipe adapter piece for the in (welded it on the pipe) I just welded a pipe on for the out
less than 2 hours and done much longer lasting than the original
Any decent welding shop should be able to help --just need the pattern from your old muffler
Dan
Add if you get a little off ---SS flex pipe cures all mistakes with the SS band clamps
Edited by Dan Loehr 2/8/2025 10:35
| |
|
862B JD scraper muffler
