|
Holly Hill, SC | Plan on making my own JD RTK base station and wanted to piece together or make my own wiring harness. Supplying power to the receiver and radio are simple enough but occasionally I will need to plug a monitor into this system to view the settings and even to start the initial survey. I am going to solder in a 26 pin monitor plug into an existing receiver harness that I have. How important is adding a CAN terminator into this harness? Added some examples of available harnesses.
Edited by shulerfarm 1/15/2025 17:40
 (20250115_180936 (full).jpg)
 (20250115_180914 (full).jpg)
Attachments
----------------
 20250115_180936 (full).jpg (81KB - 3 downloads)
20250115_180914 (full).jpg (116KB - 1 downloads)
| |
|
JD receiver to monitor cable
