Viewing a thread - Wire Crimping Tool?

You are logged in as a guest. ( logon | register )

Wire Crimping Tool?	View previous thread :: View next thread
Forums List -> Machinery Talk	Message format

ekeller2

Posted 3/1/2010 10:06 (#1099490 - in reply to #1099235)
Subject: Re: Wire Crimping Tool?

So. IL

Thomas and Betts is the only way to go. They have a special end on them and you will never pull a end off after crimped by them. They cost about $50 but well worth it.

Wire Crimping Tool? - Digger : 2/28/2010 22:15
- Vise grip nt - Kooiker : 2/28/2010 22:22
- RE: Wire Crimping Tool? - Cliff SEIA : 2/28/2010 22:22
  - Re: Wire Crimping Tool? - hoggy76 : 2/28/2010 22:26
  - RE: Wire Crimping Tool? - Von WC Ohio : 2/28/2010 22:46
    - RE: Wire Crimping Tool? - Cliff SEIA : 3/1/2010 08:15
      - RE: Wire Crimping Tool? - dslman : 3/1/2010 08:36
- RE: Wire Crimping Tool? - lylefarm : 2/28/2010 22:37
  - RE: Wire Crimping Tool? - glensts : 2/28/2010 23:23
- Re: Wire Crimping Tool? - JDTECH : 2/28/2010 22:45
- Not to ask a dumb question, but are you crimping properly? - 730diesel : 2/28/2010 23:35
  - Klein ........nt - krantz : 2/28/2010 23:39
- RE: Wire Crimping Tool? - L8Bloomer : 3/1/2010 00:40
  - Re: Wire Crimping Tool? - ekeller2 : 3/1/2010 10:06
- RE: Wire Crimping Tool? - Phred : 3/1/2010 03:26
  - RE: Soldering vs crimping - Gerald J. : 3/1/2010 11:15
- RE: Wire Crimping Tool? - CJDave : 3/2/2010 08:26

Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)