AgTalk Home
AgTalk Home
Search Forums | Classifieds (34) | Skins | Language
You are logged in as a guest. ( logon | register )

Raven autosteer stopped disengaging
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
DonOK
Posted 9/20/2024 19:45 (#10898158 - in reply to #10897970)
Subject: RE: Raven autosteer stopped disengaging



Yes, it still engages with the plug disconnected from the switch.

It's a four pin connector with two wires coming out of it. A blue and a white. So, one of those will show voltage and one will ground? Continuity between the two with the power off should indicate a short?

I have located a round connector upline. It is where the blue wire ends and changes to some other color. It then goes into the big harness that ends up at the smartrax box. I can at least disconnect there and maybe isolate the short.

Is it a normally open switch that closes when the steering wheel is turned? If so, then wouldn't it be a broken wire rather than a shorted wire?



Edited by DonOK 9/20/2024 19:53
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)