|
New Zealand | For serial corrections input you need to use pin 3 and 5 on the 12-pin port on the exp-100. Pin 3 for the signal and pin 5 for the ground.
You have to assign the port expander to act as port D. This is done in the "ports" menu in the settings. After that you have to go in Agremote and configure port D to match your external correction source. Same way as it is done on FMX.
Keep in mind that this correction input method will only work for fmx plus, not Precision-IQ, unless you use some old firmware, think it is version 4.2 or something. | |
|
Trimble TMX 2050, Implement Steering and Serial NTRIP Corrections
