|
cropsey, il 61731 | I'm installing AL autosteer on an STX325 (non-can tractor, paradyme, ecu4). I'm down to the pressure sensor on the steering valve (trimble, might be oem?) and agleader does some adapting to use the 3 pin sensor with a resistor (lower voltage to 5v from 12v I assume). I think this type of resistor setup is used elsewhere to lower the voltage and my assumption is I want to match the resistance of the ecu4 input (to halve the voltage), but I don't know if that's 10K or 100K ohms. I've attached the pdf of the harness but AL is keeping the resistance double top secret.
thanks
Attachments
----------------
 201-0492-02-A_wiring_schematic.pdf (100KB - 113 downloads)
| |
|
Resistor value in Agleader harness 201-0492-02
