AgTalk Home
AgTalk Home
Search Forums | Classifieds (95) | Skins | Language
You are logged in as a guest. ( logon | register )

Ag Leader Incommand 1200 with 7500 steady steer gps error
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
cnl12
Posted 5/30/2024 22:47 (#10757519 - in reply to #10757420)
Subject: RE: Ag Leader Incommand 1200 with 7500 steady steer gps error


Northeast NE
I had the scm not connected come up after installing the new monitor. Approximately 15 minutes later as well. Dealer brought display out to the field installed it everything booted up looked good so he left. I went back to where I quit planting and that popped up. SCM was had a red light instead of green at that point as well. I messed with the ethernet cable which was a little bit loose from the swap and then it never gave that message again and went back to gps error.
The serial gps lost has happened a few times. Normally when that happens it has dropped to the grey satellite at the same time. Have had that happen driving down the road without steering engaged as well but only a couple of times.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)