AgTalk Home
AgTalk Home
Search Forums | Classifieds (95) | Skins | Language
You are logged in as a guest. ( logon | register )

Ag Leader Incommand 1200 with 7500 steady steer gps error
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
cnl12
Posted 5/30/2024 12:22 (#10756728 - in reply to #10756691)
Subject: RE: Ag Leader Incommand 1200 with 7500 steady steer gps error


Northeast NE
This has occurred even with wide open fields with no electrical lines within a half mile. Even when along tree lines it's never bothered in years past and I don't recall it acting up along them this year.

We thought possible voltage issue as well. Put a new alternator on the tractor and didn't see any changes. For a while I ran it powered off a separate battery t sitting in the cab to isolate things. Thought it was the three pin power supply connector but turned out it wasn't just a coincidence.

Currently using it without the iso hijack cable installed and disabled the universal terminal on the monitor. It hasn't acted up but too early to tell. Unfortunately I need to use that next with the fertilizer spreader.

I just use one tractor for everything. Use tge same system in the fall in the combine. Never had issues with it. Spread fertilizer last fall with a different spreader using the agleader module instead of iso and it worked flawlessly then.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)