|
Kendall County, IL | I installed new hydraulic PWM valves on my GVM transpread and am trying to dial in setting for a more consistent spread volume instead of up and down. This Transpread uses a Raven console to control rates, no wheel drive. This spreader does work but the you can tell it searches up and down to get proper rate. Adjusting low and high offset voltage setting does nothing. How should I manually set adjust screw on PWM valve for an initial starting point? See pictures
 (IMG_1244 (full).jpeg)
 (IMG_1247 (full).jpeg)
 (IMG_1245 (full).jpeg)
Attachments
----------------
 IMG_1244 (full).jpeg (113KB - 124 downloads)
IMG_1247 (full).jpeg (95KB - 125 downloads)
IMG_1245 (full).jpeg (130KB - 131 downloads)
| |
|
Setting PWM valves dry spinner spreader with Raven
