|
northeast ohio | No idea if this would work but may be worth a try. Start the AB Curve at least 60 ft from the A point on your diagram at a heading at 90 degrees different from your original A. When you get to original A, pause circle to around and unpause at A to drive the pattern as drawn. My sense it will round the 90 but maybe not. If it works and you want an entire field like this then every guidance line would need to be shifted and should rename so sequence is obvious..
FYI - I tried doing an offset in farmer core on a similar pattern and it did the squeeze / expand as $hown in #4. Not confident though that is is equivalent to a shift using the display itself.
Edited by neo_ag 12/6/2023 04:32
| |
|
Shifting a curve in Trimble FMX
