ih1486powr - 12/5/2023 09:32 I tried unchecking pressure fallback and still have the same result, it has an alert at the top that says operating at minimum threshold, when I first take off the pressure will be 20-25 but after I speed up and then slow back down 30-35 is as low as it will go. Just saw this. Here is my recomendation. If you have a digital pressure reading on your display, leave this enabled. Otherwise, disable pressure fallback. The reason you are operating at "minimum threshold" is that the nozzle you have chosen cannot spray/pattern correctly under the speed and rate conditions you are in. Your options are: 1. Fudge the nozzle parameters 2. Speed up 3. Increase Target Rate 4. Combination of all the above |