tedbear - 12/5/2023 10:40 FarmWeather - 12/5/2023 10:59 The minimum flow is likely computed by the nozzle you have defined (if you have one defined). So the L2 is "smart enough" to know the flow characteristics (minimum pressure etc. ) for common tips? If so and one is defined maybe that tip should not be used below 30 PSI which would explain why the system is not allowing it to go below lower? L2 includes some of the features that were present in the ISO liquid module, one of which is defining a nozzle. ISO orifice sizes are available (Example: an 02 will apply 0.2 gpm at its reference pressure. Ref pressure in USA is almost always 40 PSI). The user can also define a nozzle with specific parameters. Minimum flow is calculated based on these inputs. Page 4 of the manual. Attached.
Edited by FarmWeather 12/5/2023 14:48
Attachments
----------------
 2006594-ENG_D_FUG_INCOMMAND_L2_view.pdf (2279KB - 70 downloads)
| 
In Command 1200 min/flow
