West Central Missouri | Mac Sw On - 5/26/2023 05:10
Running an Agleader Integra in a CIH magnum pulling a JD 1990 drill. Using virtual terminal to monitor drill functions. Radar on the tractor has been acting up causing no speed input into the monitor which shuts down blockage information. If we unplug radar the tractor defaults to transmission speed and we have gps speed on the Integra but can not figure out how to get virtual terminal to use either of these speed inputs. Any help greatly appreciated.
I've had the same problem on a JD Tractor using an Incommand 1200. The Ag Leader display (obviously) is connected to tractor ISOBUS. Broadcast GPS and ISO_GBSD are both turned on. The JD blockage monitor only sees tractor wheel speed. In this particular instance, the owner found that to be acceptable. He checked his seed vs field area according to the scales on the machine and the InCommand's acre count and found it to be acceptable.
I have dabbled with the idea of throwing an ITC on it just because they're available cheap, and ought to broadcast a GPS speed signal the 1990 CCS drill will accept...Theoretically could even mount the ITC on the drill... |
Agleader Integra virtual terminal problem
