|
NW NSW Australia | I am having trouble getting the nmea signal out of our itc receiver when mounting it on a quad bike to run a crop circle sensor.
I can get the signal ok when mounted on the tractor to run a laptop and the crop circle when spraying however when I try on the quad it's a no go. I have tried with both a simple harness (power & serial wires) and a greenstar one that came for base station setup with the serial wire added at the gps plug. I can pick up voltage at the DB9 from the receiver but no info.
I used to run this setup with my old receiver which is now the base station one.
I have tried different baud rates,Hz, no RTK, SF2, no SF2, no TCM. There's something simple I'm missing I'm sure. | |
|
itc & nmea signal
