|
| While planting the right hand seed drive (runs 12 rows) stopped and complained it stalled.
I unhooked the drive chain off of it and tried to get it to test with my FMX. It tries to turn but will not start.
It's a PAR2.
I've got 2 other drives on this hydraulic circuit and pressure is a little low, but over 1000#, it should be plenty, I've been running with that much pressure for the whole season without problems.
If I manually turn the drive it moves stiffly like it always dies, so it's not completely bound internally. I pulled off the electrical cover and no hydraulic fluid had leaked under the cap.
I'm praying when I put my (untested) spare on tomorrow ill be running again.
Ideas?
It's about 10 years old now, I think I sent it in 5 or more years ago to get the leaky barrel fixed, but overall I've never had this problem.
Edited by Fingers77 5/13/2023 22:32
| |
|