|
SC IA | Have a sprayer with raven components and running rate controller through FM750. Just started spraying today and it’s causing fits every once in a while. I first noticed it when I got done with a field, the actual rate was showing same as target rate, but sprayer pressure was way too low so it wasn’t registering the low rate. I checked screens first and they were ok. It started acting fine again so thought maybe was a gauge malfunction. Turns out it wasn’t as it acted up again, sprayer dropped to 20 lbs of pressure and actual rate on display was bouncing around all over the place. And it wouldn't increase pressure as I sped up. I would switch to manual pressure when it acted up to keep going so I’m sure I don’t have a mechanical issue. This is the raven flow meter I have which has never been changed. Is it possible it’s going bad and is there any way to check it?
(IMG_1354 (full).jpeg)
Attachments ---------------- IMG_1354 (full).jpeg (110KB - 58 downloads)
| |
|