|
EC Nebraska | I have searched all previous posts and can not come up with a discussion that matches my symptom...so here it goes...
We have a 9500 w/ the original GS system. Was updated to the 4/5 & 2.5 ISO awhile back and have ran it that way for several years.
When both of the terminators are connected the display gives fault code 110 (doesn't mean much, I know) and the display does not communicate with the moisture meter, mass flow sensor, or the position receiver. If I unplug either of the terminators (doesn't matter which one) everything seems to function. I have traced the wiring harness for possible broken wires and have repaired all wires that were broken or damaged. Could I have missed a broke wire somewhere? Could one or both of the terminators be bad? Can I run without one of them connected? Is there any way to test the terminators?
I am hoping that someone else has had this problem and can give me some direction. TIA
Luke
| |
|